Power Board PB-Enigma II VX for original dm800

[hafikli]

Power Board PB-Enigma II VX for original dm800

Release 2011-12-27

Based on the 3.2.1 release of Dream-Multimedia-here, the PB-E2 to VX

For the procedure:

Bring the box into the flash mode, then use the webif flash the appended hereto SSL-84, if that's not happening ... - Normally, as an image (which happens very quickly, only a few kilobytes).
Then immediately put the box back into the flash mode and then flash the image as normal.

Functions see documentation ...

... here all details

PB Power Board for DM800 Enigma II VX-original

Release 2011-12-27

Basics on Release 3.2.1 by Dream-Multimedia-VX here the PB-E2

How to:

Switch receiver to flash mode, flash by webif than SSL-84 first! - If not done yet! - As easy as a normal image (it's done very fast - only a few kilobytes).
After that bring receiver immediatly again into flash mode and flash the PB image!


Download: Powerboard_E2_VX-dm800-rel32-20111226.nfi.tar.gz gz

 

[YILMAZ&MARAZ]

PB-Powerboard Enigma II VX für die Original dm800

Release 2011-12-27

Auf Basis des Release 3.2.1 von Dream-Multimedia hier das PB-VX-E2 dazu

Zur Vorgehensweise:

Die Box in den Flashmodus bringen, dann über das webif den hier angehängten SSL-84 flashen, falls das noch nicht geschehen ist... - ganz normal, wie ein Image (das geht sehr schnell, sind nur ein paar Kilobyte).
Dann die Box sofort wieder in den Flashmodus bringen und dann ganz normal das Image flashen.

Funktionen siehe Doku...

... here all details

PB-Powerboard Enigma II VX for DM800-original

Release 2011-12-27

On Basics Release 3.2.1 by Dream-Multimedia here the PB-VX-E2

How to:

Switch receiver to flashmodus, than flash by webif SSL-84 first ! - if not done yet ! - as easy as a normal image (it´s done very fast - only a few kilobytes).
After that bring Receiver immediatly again into flashmodus and flash the PB-Image !

Funktions have a look into docu...

Powerboard_E2_VX-dm800-rel32-20111226.nfi.tar.gz​